Designed for a greater range of cutting applications including vinyl siding and vinyl fence posts and rails. A flat ground, neutral, no-hook-angle, 248-tooth configuration and nominal .073” (1.85 mm) blade thickness generates less waste and ensures a consistent ultra-smooth cut with less pull into the vinyl material. The large

Vinyl fence panels do not deteriorate, rust, decay, rot, or yellow. Vinyl fencing If you need to adjust the vinyl panels, cut them in the same way you would cut wood. Cut Vinyl Fence Turn on the chop saw and bring the rotating blade down onto the vinyl fence panel until it cuts completely through. Lift the

Vinyl fence and lattice can be cut just like wood material. Whether you're installing your own fence, or doing some other vinyl fence project, chances are you will need to Start by cutting your vinyl lattice. Cut through the lattice joint by joint using a circular saw with a vinyl-cutting blade. If you don't have a

Keep in mind that when you install vinyl fencing you have to place the posts in the ground deeper than wood or metal posts. This extra depth Continue in this fashion until you are completely through the piece you are working on. Continue cutting through the vinyl fence pieces until they are all cut and ready to be installed.

Vinyl is becoming more desirable as an alternative to wood fencing, rails and lattices. It's sturdy, holds In general, any sharp, medium- or fine-toothed saw blade can be used to cut vinyl lattice, according to U.S. Fence. A carbine blade blade is sharp. A dull blade is far less likely to cut through vinyl cleanly and smoothly.

How do I cut vinyl? buildingvinyl-2.jpg. Vinyl fencing is a rigid form of plastic. Consequently, when you attempting to cut with a wood blade, you can expect the If the slope is so severe that you are unable to get the rail into the standard post pockets, place the rail parallel to the existing grade and flush along the side the

When cutting through metal, don't just start slow, but keep it slow through the entire cut. This will prevent overheating and increase the longevity of the blade. As a plumber I've seen guys burn through multiple blades on on section of cast iron pipe using the highest speed, when you slow it way down you