spacers assure drying of the 2x her ledger. Double flashing over the top of the ledger is also a good practice. The house rim joist must be securely anchored to the house framing and it must be sitting on the foundation wall. Deck lateral load connection. The 2009 IRC now requires th decks shall be attached to buildings with

Max gap between ledger and wall sheathing is ½ in so no, you can't use the ½ in. bolt with spacer option over the siding unless it's T 1-11. Bolts and screws must be located 2 in. down from top and up from bottom of ledger and staggered up-down. Plus you need to double fasteners at ledger butts and

Integrating the deck ledger with these two systems - without compromising them - is critical for the house and the deck. Otherwise, water will One way to stop water from collecting in the groove in between them is to space the joists apart with pressure-treated plywood spacers (Figure 3). Because I usually

Flashing deck ledger boards properly is one of the most important details for new decks. Read this article to learn how to flash deck ledger boards includes diagrams.

by the local building department before construction begins. Ledger Attachment. For more information on ledger attachment see Fastening Systems catalog C-FS and flier F-SDWSSDWH. Exterior cladding and flashing not shown for clarity. Floor joist or blocking. 2" nominal deck ledger shown. (double 2" ledger similar).

If you want to build a great deck, don't do what most builders do. Too many decks are fastened incorrectly, and most decks drive people crazy with maintainnence. Avoid all these problems with my video ebook Love Your Deck. This video is one of more than 10 videos that are part of the book. Check it all

Learn how to properly install a waterproof deck ledger board using flashing and fasteners. Check out our step by To double-check for level, hold a 4- or 8-foot level against the chalk line. [tip] Other Ways to Use the 1-1 4" spacer board to position the siding at the correct height, and drive nails to fasten it. Lay out for the

Traditionally, lag screws have been the most common method of attaching decks to buildings. To properly attach a deck ledger using 1 2″ lag screws, 5 16″ holes need to be pre-drilled through the ledger and rim joist. After that, a 1 2″ hole should be drilled through the ledger only. For specific spacing

That means using double-hot-dipped galvanized nails or, better yet, stainless steel nails for all nailing, and exterior-rated joist hanger nails. You can also use special screws designed for composite decking or buy hidden fasteners designed for decking, though these get expensive. Install drip cap above the ledger and