Stringers act like ladders steps and are necessary to help hold your deck stairs in place. When they fall on uneven ground they can become misaligned over time. The best way to solve this problem is to use a level across each tread that you cut. This helps to keep the stringers aligned, which add stability to the steps you're

For example, if the yard has a slope down going away from the deck, more distance covered by treads will require more total rise, so you might add an additional step to accomplish a more desirable step profile or to land at a point where the ground is more even so less grading would be required. You can

But in this story, we'll make it easy by showing you how to estimate step dimensions, layout and cut stair stringers, and assemble the stair parts. And you won't have to do any hard math to On uneven ground, find the number of treads so you can find the exact stair landing point. Simply subtract 1 from the number of risers.

Put more steps closely spaced on steep slopes, fewer steps with wider treads or landings on gentle slopes. Design steps to be level, even if the ground slopes up and down or sideways. Use side stones or walls to build up or hold back uneven ground on the sides of the steps. Make a short wall if there is a

If individual stair risers are not calculated and laid out and then of course cut correctly and I guess I could even suggest installing them incorrectly also, then you could have I have had a patio door installed, the ground (concrete pad) to the door sill is 28' on the left side 29.5' middle and 31'on the right.

forget about the floor and the house for now just build it. once its built then use your spirit level to make the stairs level and fix the top in place temperarily. then there should be a gap on one stringer at the bottom. use a rule or piece of timer sitting on the ground and mark off from the ground to make sure that

Usually, one of two design options is used: deck stairs on the stair stringers or on the bridge board. When you have to install the deck on uneven ground, the platform is better to be mounted on a columnar concrete base: the piles are immersed into 20 inches deep pits the bottom of which is poured with a thick layer of

You might guess it was the walls below the stairs, but actually stairs are self-supporting structures that are held up by their stringers, the long pieces to which each tread is fasten. Because deck stairs may land on uneven ground or on a wavy concrete pad, the stringers eventually move out of alignment.

Now we are building a second story deck and the stairs will land on the cement patio. Fixing an uneven Stair Landing Firstly if you are a confident carpenter you could trace out your stair stringers as normal but before you cut them to length add 3 4" to the bottom side of the stringer that needs to be